Air-Tite Holder - Direct Fit - 30.6mm (Half Dollar ) -- Bulk Pack

Perfect for 30.1mm Coins and Medallions -- The T30 capsule works well with coins up to 1/8 inch thick.   For coins not in the list below, check to make sure their diameter and thickness do not exceed the measurements shown below for Inside Diameter and Inside Depth respectively.  To the extent the coin diameter is smaller than the Inside Diameter noted below this can allow for minor movement of the coin inside of the capsule.

Direct fit holders require a snug fit between the coin and the holder to keep the coin in place. Air-Tites exacting manufacturing process ensures that an Air-Tite will always fit the coin it was intended to hold. These holders have been designed to hold almost every type of US coin, medallion and bullion. This holder will accommodate coins with an outside diameter of 30.6mm and a thickness of 3.17mm. 

Bulk packaged capsules do not have retail packaging resulting in less space and lower cost.  Bulk boxes of 250 (pictured above) and pre-made smaller packs of 10, 20, 25, 50 or 100 capsules are packaged with the capsules between layers of foam.  Capsules are shipped unassembled.   We also have the T30 capsule available in retail blister packaging.

There are a variety of compatible "T" size storage and display products including:

• Storage boxes
• Presentation cases
• Album pages

The T30 Direct Fit Air-Tite Holder is recommended for:

	Capped Bust Half Dollar--Reeded Edge (1836-1838)    Liberty Seated Half Dollar (1839-1891)    Barber (aka Liberty Head) Half Dollar (1892-1915)    Liberty Walking Half Dollar (1916-1947)    Franklin Half Dollar (1948-1963)    Kennedy Half Dollar (1964-present)    Classic Commemorative Half Dollar (1892-1954)    Modern Commemorative Half Dollar (1982-present)
United States
	Half Dollar (1908-1967)
Canada

Inside Diameter: 1.500 inches (38.1mm)
Outside Diameter: 1.75 inches (44.45mm)
Inside Depth: 0.125 inches (3.17mm)
Outside Thickness: 0.213 inches (5.4mm)